Installation method of cable trays for pipe gallery

Cable trays in a pipe gallery should be installed with proper planning, secure supports, adequate clearance from pipes, and adherence to approved drawings and safety standards.

Planning and Preparation

Before installation, review approved shop drawings, material submittals, and project specifications. Conduct a site inspection to ensure the area is clear, safe, and accessible, and coordinate with other trades to avoid interference with existing pipes or HVAC systems . Identify the tray route, including bends, tees, and elevation changes, and mark support points using a chalk line or laser level .

Tray Selection and Sizing

Choose the appropriate tray type based on load and environment: ladder trays for heavy cables and airflow, perforated trays for lighter loads, and solid-bottom trays for protection against dust or liquids . Calculate tray width and depth according to cable count, type, and spacing guidelines to prevent overheating and ensure future expansion .

Supports and Mounting

Cable trays must be supported independently of process piping. Minimum clearance from pipe surfaces should be 300mm for parallel runs . Supports can be installed using:

• Wall-mounted cantilever brackets: Drill holes, insert anchors, and secure brackets level to the wall .
• Ceiling suspension (trapeze or C-hanger): Install threaded rods with Unistrut channels to create a horizontal shelf for trays .
• Fabricated supports: Ensure they are designed to carry the tray load and future cable additions . Support spacing typically ranges from 1.5 to 3 meters, depending on tray type and load .

Installation Procedure

1. Inspect trays and accessories for damage or coating defects before installation .
2. Cut trays to required lengths using a hacksaw or angle grinder, and deburr edges to prevent cable insulation damage .
3. Place trays on supports and secure with hold-down clips or bolts to prevent movement .
4. Join tray sections using couplers or splice plates, ensuring alignment and continuity .
5. Maintain proper alignment using spirit levels or laser levels, and allow for thermal expansion where necessary .
6. Bond all trays to the main earthing system using copper conductors to ensure electrical safety .

Safety and Compliance

• Use PPE including gloves, safety glasses, and hard hats .
• Install warning signs and barriers in the work area .
• Follow NEC or local electrical codes for tray fill ratios (usually max 50%) and grounding requirements .
• Document inspections and approvals for QA/QC compliance .

Additional Considerations

• Avoid supporting trays from process piping .
• Apply zinc-rich paint to any cut or welded portions to prevent corrosion .
• Maintain segregation of power, data, and control cables using color coding or separate trays .
• Ensure the tray system is continuous without mechanically discontinuous segments . By following these steps, cable trays in a pipe gallery can be installed safely, efficiently, and in compliance with project specifications and electrical standards.